๐Buy orders
Last updated
Last updated
To access the Buy orders, press ๐คManual Buyer in the main menu or paste a live contract address/link and click Limit Order at the bottom left of the menu: To register the Limit order, click any of the Buy buttons. You will be presented with a new window that will contain your order information: Some information will be displayed: Contract address, At what Mcap the order will be completed, How much ETH you are spending | Gas/Tip used | How many wallets used, Etherscan link. You should leave this window open, if you press โCancel, the order will be cancelled. If these buttons are pressed, an order will be registered without any confirmations! These values can be customized in the settings: ๐ฐ Buy X ETH will let you specify the exact amount of ETH that you would like to purchase. Your order will be registered upon pressing enter!
The token is resimulated every single block, and the information gets updated automatically. Pool Info: Routing DEX, Market cap in USD, Liquidity | % of tokens that are still in the liquidity pool. Token Info: Buy | Sell taxes, Max transaction in % (if there is one), Supply that is burnt in % (sent to a dead address), Supply that will be dumped by the contract when it becomes unclogged in %. Useful links, Your Sigma level [Current experience/Experience for next level].
There are 3 options to choose on when to buy the dip: The % from current market cap mode: The custom market cap mode: And token price mode:
Specify the wallets you would like to purchase the token with: Pressing All button will select all of your wallets: Make sure to setup enough wallets before placing an order! To change the amount of ETH you would like to pay for your transaction (Gas/Tip), please click the โฝ๏ธMev button: And enter your desired value:
AntiRug is an all-in-one protection from all the things that are nasty - rugs, taxes, blacklists and everything in-between. You can enable/disable it by clicking this button: AntiRug will sell on high-impact sells, for example if dev dumps 10 wallets at once, the bot will frontrun these transactions. Red is disabled, green is enabled. You can enter a custom Slippage value by pressing Slip: Slippage is calculated after taxes. For example, if you plan to buy a token with 1 ETH, and there's a 50% tax on the token, your initial 1 ETH will be reduced to 0.5 ETH due to the tax. Then, the slippage is applied. Consequently, the actual minimum amount you'll end up buying may be much less than 0.5 ETH. For tax protection you can select the maximum buy and sell taxes in the settings. Slippage is calculated not on token price fluctuation, but on the amount you are trying to buy. For example: You are trying to buy 1 Eth worth of Pepe and you have slippage set at 50%. This means that right after buying you are accepting that your tokens will be worth anywhere from 0.5 Eth to 1 Eth (if taxes are at 0%) Keep in mind, there is no anti-mev on Binance Smart Chain, so please use Slippage!
You can set as many simultaneous orders as you like in the bot, just keep entering your desired settings and creating orders!
To see all of your pending buy orders, /start the bot and press the ๐Pending orders button: Or type /orders in the bot. You can cancel any of your pending buy orders in the following menu: Completed orders will be deleted automatically. If an order completes, a new window will pop up: